Crown Wheel and Pinion

Crown Wheel and Pinion Sets for Industrial Drives, Made as Matched Spiral Bevel Pairs.

Crown Wheel and Pinion

Specifications

Business Established2015
NatureManufacturing
Maximum Gear DiameterUp to 1200 mm
Module RangeModule 1 to 25
Maximum Face WidthUp to 150 mm
RatiosAs per drawing and requirement
Cutting, Lapping and GrindingAvailable in-house under one roof
Accuracy ReferencesDIN, AGMA and customer-specific requirements
QuantitiesPrototype through production
Reverse EngineeringAvailable

The Crown Wheel and Pinion

A crown wheel and pinion is a matched pair of bevel gears: a small pinion that meshes with a large crown wheel, turning the drive through 90° and reducing speed. The pinion sits on the input shaft and the crown wheel on the output shaft or a flange. Most sets are spiral bevel; older and slower machines may use straight bevel teeth. The ratio of the set decides the output speed and torque of the drive.

Why the Set Matters

Crown wheel and pinion sets carry high torque with frequent shock loads. They are lapped or ground as a pair and must stay together. The pinion's position, set by shims at assembly, controls the contact pattern; backlash is set by the crown wheel position. A set that is mismatched or badly set up wears quickly and runs noisily.

What We Make

  • Crown wheel and pinion sets for industrial gearboxes, right-angle drives and machine drives
  • Sets for industrial differential drives
  • Sets made from a worn sample, including for imported machines no longer supported
  • Ratios as per the original or as required

Every set is checked for contact pattern and backlash, marked with a set number and packed as one unit. We make crown wheel and pinion sets for industrial machinery only, not for vehicles.

What to Send

The old set if possible, with the machine make and model, ratio (tooth counts), and whether the crown wheel bolts to a flange or case. Include the pinion's splines and bearing journals.

Frequently Asked Questions

Can I change the ratio of my crown wheel and pinion?

Sometimes, within the space in the housing. Send the existing set and the ratio you want and we will check.

Why must the crown wheel and pinion be replaced together?

They are finished and checked as a pair. A new pinion with an old crown wheel will not give a correct contact pattern.

How do I set up a new crown wheel and pinion?

Set the pinion depth with shims to the marked dimension, then backlash with the crown wheel, and check the contact with marking compound. See our backlash and contact pattern guide.

Do you make crown wheel and pinion sets for vehicles?

No. We make them for industrial machinery only.

Related Products

Request a Quote for Crown Wheel and Pinion

Share your drawing, sample details, quantity and delivery location. Our engineering team will review it and reply.