Straight Bevel Gear
Straight Bevel Gears for Slower Right-Angle Drives, Valves, Hand-Operated Machinery and Simple Gearboxes.

Specifications
| Business Established | 2015 |
|---|---|
| Nature | Manufacturing |
| Maximum Gear Diameter | Up to 1200 mm |
| Module Range | Module 1 to 25 |
| Maximum Face Width | Up to 150 mm |
| Ratios | As per drawing and requirement |
| Cutting, Lapping and Grinding | Available in-house under one roof |
| Accuracy References | DIN, AGMA and customer-specific requirements |
| Quantities | Prototype through production |
| Reverse Engineering | Available |
Where Straight Bevel Gears Fit
Straight bevel gears have straight teeth that, if extended, would meet at the apex of the pitch cone. They engage along the whole tooth length at once, which makes them simple to make and to mount, with relatively low axial thrust. Because one tooth pair takes the load at a time, they get noisier as speed rises.
They remain the right choice for:
- Slow and moderate-speed drives, typically where pitch-line speed is low
- Valve actuators, sluice gates and manually operated mechanisms
- Agricultural implements and simple gearboxes
- Differential side gears and planet gears
- Replacing existing straight bevel gears in older machines
Straight or Spiral?
If the drive runs faster, carries shock loads, or must be quiet, a spiral bevel or Zerol set is usually better. A Zerol set can often replace a straight bevel set in the same mounting, because its thrust behaves the same way. See our comparison guide.
What We Make
Straight bevel gears and pinions up to 1200 mm diameter, module 1 to 25 and face width up to 150 mm, in carbon steel, alloy steel (case hardened), stainless steel or other materials to suit the duty. Single parts, matched pairs and series quantities.
Frequently Asked Questions
Up to what speed can straight bevel gears run?
They are best kept to low and moderate speeds. As speed rises, noise and dynamic load increase; spiral or Zerol gears are then preferred.
Do straight bevel gears need to be replaced as a pair?
It is good practice, especially when worn. A new gear on a worn pinion will not share load properly.
Can you make straight bevel gears from a sample?
Yes. Send both parts if possible, with the shaft angle and mounting details.
Related Products
Spiral Bevel Gear
Custom Spiral Bevel Gears and Matched Gear-and-Pinion Sets Up to 1200 mm Diameter and Module 25, Cut.
View details →Bevel Gear
Straight, Spiral, Zerol, Hypoid and Miter Bevel Gears Made to Drawing, Sample or Application Data, Up to 1200 mm Diameter.
View details →Crown Wheel and Pinion
Crown Wheel and Pinion Sets for Industrial Drives, Made as Matched Spiral Bevel Pairs.
View details →Request a Quote for Straight Bevel Gear
Share your drawing, sample details, quantity and delivery location. Our engineering team will review it and reply.