Hardened Spiral Bevel Gear

Case-Hardened Spiral Bevel Gears with the Case Depth and Surface Hardness Chosen for the Module and the Duty.

Hardened Spiral Bevel Gear

Specifications

Business Established2015
NatureManufacturing
Maximum Gear DiameterUp to 1200 mm
Module RangeModule 1 to 25
Maximum Face WidthUp to 150 mm
RatiosAs per drawing and requirement
Cutting, Lapping and GrindingAvailable in-house under one roof
Accuracy ReferencesDIN, AGMA and customer-specific requirements
QuantitiesPrototype through production
Reverse EngineeringAvailable

Why Bevel Gears Are Case Hardened

A gear tooth needs a hard surface to resist pitting and wear, and a tough core to resist bending fatigue and shock. Case hardening gives both. Low-carbon alloy steels are carburised so the surface layer takes up carbon, then hardened. The surface typically reaches around 58–62 HRC while the core stays tough.

Commonly used case-hardening steels include 20MnCr5, 17CrNiMo6 (18CrNiMo7-6), EN353 and SAE 8620. Your drawing may specify one; if it does not, we suggest one for the size and duty.

Getting the Case Right

  • Case depth follows the module. A case that is too shallow pits; one that is too deep makes teeth brittle. The effective case depth is chosen for the module and load.
  • Distortion is planned for. Teeth distort a little in hardening, so stock is left for lapping or grinding afterwards. Both finishing routes are done in-house.
  • Hardness is recorded. Surface hardness, and where specified core hardness and case depth on a test piece, are checked and recorded.

Other Hardening Routes

Through-hardened or induction-hardened gears can suit some larger, slower gears and repair jobs. Tell us the duty and we will recommend the route.

Size range: up to 1200 mm diameter, module 1 to 25, face width up to 150 mm. Read more in our materials and heat treatment guide.

Frequently Asked Questions

What surface hardness do your hardened gears have?

Case-hardened bevel gears are typically finished at about 58–62 HRC on the surface, or to the value on your drawing.

Which steel do you recommend for a heavy-duty spiral bevel set?

For heavy shock loads a nickel-chromium-molybdenum steel such as 17CrNiMo6 is common; 20MnCr5 suits many industrial sets. We confirm it against size and duty.

Can you supply hardness and case depth reports?

Yes, surface hardness is recorded for each set, and case depth on a test piece where specified.

Related Products

Request a Quote for Hardened Spiral Bevel Gear

Share your drawing, sample details, quantity and delivery location. Our engineering team will review it and reply.