Stainless Steel Bevel Gear

Straight Bevel and Miter Gears in Stainless Steel for Washdown, Food, Pharmaceutical, Chemical and Marine Machinery, Made to Drawing or Sample.

Stainless Steel Bevel Gear

Specifications

MaterialStainless steel to your grade, e.g. 304, 316, 410, 420, 17-4 PH
Gear TypeStraight bevel and miter gears
Maximum Gear DiameterUp to 1200 mm
Module RangeModule 1 to 25
Maximum Face WidthUp to 150 mm
QuantitiesOne-off replacement to repeat batches
From a SampleYes, reverse engineering available

Stainless Steel Bevel Gears for Corrosive and Hygienic Duties

Many right-angle drives in process plants are slow and lightly loaded: a valve actuator, a conveyor turn, a dosing or packaging mechanism. For these, a straight bevel or miter gear in stainless steel is often the simplest and most durable choice. It needs no coating, survives washdown and does not shed rust into the product.

Where stainless bevel gears are commonly used:

  • Food, dairy, bakery and beverage machinery
  • Pharmaceutical and cosmetic process and packaging equipment
  • Valve actuators and hand-operated drives in chemical plants
  • Water and effluent treatment, desalination and marine fittings

Straight Bevel or Miter

A straight bevel gear pair gives a speed change at a right angle. A miter pair has the same number of teeth on both gears, so it only turns the drive through 90° without changing speed. Both have simple straight teeth, which suits the moderate speeds of most washdown machinery. Where the drive is faster, more heavily loaded or must run quietly, a stainless steel spiral bevel gear set is the better choice.

Grades

We make the gear in the grade on your drawing. Austenitic grades such as 304 and 316 are the usual choice for food and marine duty; hardenable grades such as 410, 420 and 17-4 PH are used where wear or load is higher. If you are unsure, send the application details and we will discuss the options.

What We Make

  • Stainless steel straight bevel and miter gear pairs
  • Bores, keyways, hubs and set-screw holes machined to your drawing
  • One-off replacements copied from a sample, and repeat batches
  • Sizes up to 1200 mm diameter, module 1 to 25, face width up to 150 mm

See also our standard straight bevel gears and miter gears.

Frequently Asked Questions

Do stainless steel bevel gears need lubrication?

Yes. Stainless gears still need a lubricant suited to the duty; in food and pharmaceutical machines a food-grade lubricant is normally used.

Can you make a stainless steel miter gear pair to match an existing one?

Yes. Send the old pair or a drawing with the number of teeth, module or pitch, bore and hub dimensions.

When should I choose spiral teeth instead?

When the drive is faster, carries more load or must run quietly. Spiral teeth share the load across more teeth and run more smoothly.

Related Products

Request a Quote for Stainless Steel Bevel Gear

Share your drawing, sample details, quantity and delivery location. Our engineering team will review it and reply.