Replacement Spiral Bevel Gear

Matched Replacement Spiral Bevel Gear and Pinion Sets for Worn, Broken or Obsolete Drives, Made to the Original Fit or Upgraded for the Duty.

Replacement Spiral Bevel Gear

Specifications

Business Established2015
NatureManufacturing
Maximum Gear DiameterUp to 1200 mm
Module RangeModule 1 to 25
Maximum Face WidthUp to 150 mm
RatiosAs per drawing and requirement
Cutting, Lapping and GrindingAvailable in-house under one roof
Accuracy ReferencesDIN, AGMA and customer-specific requirements
QuantitiesPrototype through production
Reverse EngineeringAvailable

When a Replacement Is Needed

A spiral bevel set is usually replaced for one of four reasons: the teeth are pitted or scored, a tooth has broken, noise and backlash have grown beyond what adjustment can fix, or the maker no longer supplies spares. In every case the answer is a new matched set. Fitting one new member against a worn mate shortens the life of both, because the two wear to each other.

What We Supply

  • A matched gear and pinion, cut and lapped together and marked with one set number
  • Pinions with the integral shaft, splines, keyway or thread of the original
  • Gears with the original bore, hub, flange and bolt-hole pattern
  • The same material and hardness as the old set, or a stronger option where the old one was undersized
  • A ground finish instead of lapping where the drive needs lower noise or higher speed

Copy or Upgrade

Most replacements are straight copies, made so the set drops into the existing housing and bearings. Before we copy, we look at how the old set failed. Early pitting or tooth breakage often means the steel, case depth or finish was not right for the load, and a hardened set in a better grade can last several times longer in the same space. Scoring or a one-sided contact pattern usually points to mounting, bearings or lubrication, and we tell you what to check so the new set is not asked to survive the same fault.

Typical Replacement Jobs

Imported gearboxes whose makers no longer supply spares, crusher and mill drives, conveyor and elevator heads, mixers, machine-tool heads and older plant machinery are the usual jobs. Breakdown orders are treated as urgent, and the delivery time is stated with the quotation.

Before You Order

Send both the worn pinion and gear if you can, with the machine make and model, ratio and the failure history. If only one part survives, we can often still work from it, but the result is more dependable with both. How we study a sample is explained on our reverse engineering page, and the RFQ checklist lists what to include.

Frequently Asked Questions

Can you make a replacement from a broken gear?

Often yes, if enough of the teeth and the mounting features remain. The mating part makes the result more dependable.

Should the gear and pinion be replaced together?

Yes. A worn pinion and gear have worn to each other, and a new member run against an old mate wears quickly and runs noisily.

Will the new set fit without changing the gearbox?

That is the aim. We match the bore, mounting distance and spline or keyway details of the original so the set fits the existing housing and bearings.

Can the replacement be stronger than the original?

Yes. If the old set failed early we can propose a tougher steel, a deeper case or a ground finish, as long as the geometry still fits your housing.

How long does a replacement take?

It depends on size, material availability and heat treatment. We give a delivery time with the quotation and can prioritise breakdowns.

Related Products

Request a Quote for Replacement Spiral Bevel Gear

Share your drawing, sample details, quantity and delivery location. Our engineering team will review it and reply.