Hypoid Gear

Hypoid Gear Sets with Offset Pinion Axes, for Compact Industrial Right-Angle Drives That Need High Torque and Quiet Running.

Hypoid Gear

How Hypoid Gears Differ

A hypoid set looks like a spiral bevel set, but the pinion axis is offset from the gear axis instead of meeting it. That offset has several effects:

  • The pinion can sit lower (or higher) than the gear centre, which gives more freedom in how the drive is laid out
  • The pinion is larger than a spiral bevel pinion for the same ratio, so it is stronger
  • More teeth are in contact and the mesh is quieter
  • The teeth slide along each other more than in spiral bevel gears, so hypoid gears need suitable extreme-pressure (hypoid) gear oil

Where They Are Used

Hypoid gears are used in industrial right-angle gearboxes and special drives where a compact, quiet, high-ratio stage is needed. We make hypoid sets for industrial machinery only, not for vehicles.

What We Make

Hypoid gear and pinion sets, made to drawing or developed from a worn sample, as matched sets that are lapped or ground, then checked and marked together. Size range up to 1200 mm diameter, module 1 to 25, face width up to 150 mm.

For matched gear-and-pinion sets, see also crown wheel and pinion. For the difference between the two types, read our guide spiral bevel vs hypoid gears.

Frequently Asked Questions

How do I know if my set is hypoid?

Look at the pinion: if its axis passes above or below the centre of the gear instead of through it, the set is hypoid.

Can a hypoid set replace a spiral bevel set?

Not directly: the offset changes the housing geometry. Replace like with like.

What oil do hypoid gears need?

An extreme-pressure gear oil of the grade and specification stated by the equipment maker, because of the sliding between the teeth.

Related Products

Request a Quote for Hypoid Gear

Share your drawing, sample details, quantity and delivery location. Our engineering team will review it and reply.