Bevel Gear Materials
Alloy, Carbon, Nitriding and Stainless Steels, Bronze and Cast Materials Used for Spiral Bevel and Bevel Gears, and How the Grade Is Chosen Against Duty.
Material Selection Starts with Duty
Torque, speed, shock load, operating hours, lubrication, temperature, contamination, required life and the condition of the mating gear all decide the material. We work to the grade on your drawing. Where the grade is not stated, or a worn sample has to be matched, we suggest a grade from the duty and confirm it with you before cutting.
Material Families We Cut
- Case-hardening alloy steels such as 20MnCr5, 16MnCr5, 8620, 18CrNiMo7-6 and EN353. A hard wear-resistant surface over a tough core. This is the usual choice for spiral bevel gears, crown wheels and pinions, and hypoid sets.
- Through-hardening alloy steels such as 42CrMo4 (EN19) and EN24, for heavier sections and moderate surface loads, where tooth strength matters more than surface hardness.
- Medium-carbon steels such as C45 and EN8, for lightly loaded gears, low speeds and straight bevel and miter gears.
- Nitriding steels such as 34CrAlMo5, where very low distortion is needed after finishing.
- Stainless steels. 304 and 316 resist corrosion but cannot be hardened by heat treatment, so they suit light duty. 410, 420, 431 and 17-4 PH can be hardened, and suit food, marine and chemical environments.
- Bronze and cast materials such as phosphor bronze, aluminium bronze, cast iron and SG iron, for specific duties such as marine drives, low-speed open gears and a softer member in a mated pair.
Starting Stock
Gear blanks are normally made from forged or rolled bar. Forged blanks give a favourable grain flow through the teeth and are preferred for heavily loaded and larger gears. Smaller gears are usually turned from bar.
Gear and Pinion Are Chosen Together
The pinion runs more often than the gear and its teeth are loaded harder. For that reason the pinion is often made from a better grade or given a higher hardness than the gear. If you are replacing one member, tell us what the other is made of.
Certificates and Traceability
Mill test certificates for the bar or forging can be supplied with the order when asked for at the quotation stage. Please state the grade and any standard (EN, DIN, AISI, IS) on your enquiry.
Frequently Asked Questions
Which steel is used for spiral bevel gears?
Case-hardening alloy steels such as 20MnCr5, 16MnCr5, 8620 and 18CrNiMo7-6 are the usual choice, because they give a hard tooth surface over a tough core. The grade on your drawing is followed.
Can you make bevel gears in stainless steel?
Yes. 304 and 316 resist corrosion but cannot be hardened by heat treatment, so they suit light duty. 410, 420, 431 and 17-4 PH can be hardened for higher loads.
Do you supply material certificates?
Mill test certificates for the bar or forging can be supplied when requested at the quotation stage.
Our drawing does not state the material. What should we do?
Send the duty details, or the worn sample and its mating gear. We suggest a grade and confirm it with you before cutting.
Send Your Requirement
Share your drawing, sample details, quantity and delivery location. Our engineering team will review it and reply.